How To Use FrogTape reMOVEables™

Make sure the surface is clean and dry, removing any dust or debris. Make sure to wait seven days after painting to apply the wall hook to the surface.

Remove the strip from the sheet and press evenly on the baseplate. Next, remove the liner from strip and press the hook to desired mounting surface. After that, press and slide up to remove hook from base plate. Make sure to apply even pressure to the base plate for at least 15 seconds. Then, slide the hook back onto the base plate until it is locked in place and wait at least one hour before use.

Press and slide up to remove the hook from the baseplate. Holding the edges of the base plate, grab tab below the line and pull directly down on the adhesive strip slowly. Important: pulling away from the wall will cause damage, so keep the strip and tab close to the wall when stretching to remove.

Make sure the surface is clean and dry, removing any dust or debris. Make sure to wait seven days after painting to apply the wall hook to the surface.

Remove the liner from one side of the strip and press to the hook firmly and evenly. Next, remove the liner from the exposed side of the strip and press hook to desired mounting surface. After that, make sure to apply even pressure to the hook for at least 15 seconds. Wait at least one hour before use.

Hold edges of the hook, grab the tab below and pull straight down slowly. Important: pulling away from the strip will cause damage, so keep the strip and tab close to the wall when stretching to remove.

Make sure the surface is clean and dry, removing any dust or debris. Make sure to wait seven days after painting to apply the wall hook to the surface.

Remove two strips from the sheet and press them next to each other on the back of the picture hanger. Next, remove the exposed liners and press the picture hanger to the wall, firmly and evenly for at least 15 seconds. After that, the center peg can slide up or down, using the red piece to lock in place at the desired height. Wait one hour before use.

Pull the tabs straight down slowly, one at a time. Important: pulling away from the strip will cause damage, so keep the strip and tab close to wall when stretching to remove.

Make sure the surface is clean and dry, removing any dust or debris; wait seven days after painting to apply strips to surface.

Snap together the desired number of pairs of picture hanging strips. Four pairs are suggested to hold the maximum weight. Next, remove one side of the liner and then press firmly and evenly to the corners of the frame. After that, remove the remaining liner, press the frame firmly to wall and hold for at least one minute.

Detach the mounted item from the surface by separating strips and leaving wall strip attached. Next, remove the individual strips, grab the edge of tab below the line and pull down slowly to remove. Important: pulling away from the wall will cause damage, so keep the strip and tab close to the wall or item when stretching to remove.

Make sure the surface is clean and dry, removing any dust or debris; wait seven days after painting to apply strips to surface.

Remove the liner from one side of the strip and press to the corner of the poster. Repeat for all corners. Next, remove the liner from the exposed side of the strips and press each area to the wall for 15 seconds.

Pull the square end of the tab straight up or down slowly, keeping it parallel with the surface. Important: pulling the strip away from wall will cause damage, so keep strip and tab close to the wall when stretching to remove.